Adhesion Promoter Clear Sealer, for Plastic, Primer, Paint, TRC-500-Q, 1 Quart

Description

This sale is for Adhesion Promoter Clear Sealer, Use on Plastic, Primer and Old Paint, TRC-500-Q, 1 quart
Eliminate peeling problems, especially in problem areas like TPO plastic bumpers. Prevents Peeling, Fills Sand Scratches, Increases Flex
DESCRIPTION:
TRC-500 Sealer and Adhesion Promoter is a 50 state VOC compliant, single component product that can be used as an adhesion promoter and flex agent in one. Fast drying and provides excellent adhesion on all flexible and rigid plastic parts.
FEATURES:
●
Single Component
●
Quick Drying
●
Adhesion Promoter and Flex Agent in one
●
No Mixing Required unused product can be returned back to can.
● Excellent for use ground effect, new flexible and rigid bumpers, plastic interior and exterior parts.
● 50 State VOC Compliant.
COMPATIBLE COATINGS:
TRC-500 is compatible with all solvent based urethane, epoxy, or acrylic lacquers, primer, sealers and basecoats.
COMPATIBLE SUBSTRATES:
TRC-500 can be used on all automotive plastics, primers and previously painted surfaces. Also
excellent for use ground effect, new flexible and rigid bumpers, plastic interior and exterior parts.
PACKAGING:
Part Number
Description
Size
Qty. Cs.
TRC-500
Sealer and Adhesion Promoter
Quart
12
TRS-500-1
Sealer and Adhesion Promoter
Gallon
4
PREPARATION:
Clean all areas to be painted with SMR-SCUFF Scuff Paste and rinse thoroughly with water. Thoroughly blow making sure surface is completely dry.
APPLICATION:
Shake Well and filter, apply one even medium coat using a 1.2mm – 1.3mm spray gun tip ensuring uniform coverage.
If 2 coats are required apply first coat in a light mist coat. Allowing 3-5 minutes between coats. Wait 10 - 15 minutes, or when tack free, before applying the next coating.
Dry times vary with film build, temperature and humidity.
If applying basecoat over TRC-500, spray light coats of base until uniform color is achieved, DO NOT apply heavy coats of base coat.
NOTE:
If parts are left to sit more than 24 hours surface must me scuffed and another coat of TRC-500 must be applied.
CLEANING:
Clean spray gun with gun cleaner or lacquer thinner immediately after use.
Health and Safety:
See Material Safety Data Sheet and labels for additional safety information and handling instructions.
The contents of this package may have to be blended with other components before the product can be used. Before opening the packages, be sure you understand the warning messages on the labels and MSDS’s of all components, since
the mixture will have the hazards of all its parts.
Improper handling and use, for example, poor spray technique, inadequate engineering controls and or lack of Personal Protective Equipment (PPE), may result in hazardous conditions or injury.
Follow spray equipment manufacturer’s instructions to prevent personal injury or fire.
Provide adequate ventilation for health and fire hazard control.
Follow company, product MSDS and respirator manufacturer’s recommendations for selection and proper use of respiratory protection. Be sure employees are adequately trained on the safe use of respirators per company and regulatory
requirements.
Wear appropriate PPE such as eye and skin protection. In the event of injury, see first aid procedures on MSDS.
Always observe all applicable precautions and follow good safety and hygiene practices.
Posted with
eBay Mobile
On Nov-19-13 at 08:48:47 PST, seller added the following information: